Application Guide By  Printomize America when using our DTF Transfer

Warm /Cold Peel Film 
Firm Pressure, Temperature: 250-270° F, Time: 10-12seconds

  • Preheat garment for 5 seconds to remove moisture
  • Place transfer on garment
  • Cover with Teflon Sheet or Parchment Paper
  • Apply design at 250-275°F
  • Use firm pressure for 12-15 seconds
  • Peel Cold
  • Cover transfer again with parchment paper
  • Post-press for 2-4 seconds to seal edge of transfer

Instant Hot Peel 
Heavy Pressure, Temperature: 280-320° F, Time: 10-12seconds

  • Preheat garment for 5-seconds to remove moisture
  • Place transfer on garment
  • Cover with Teflon Sheet or Parchment Paper
  • Apply design at 290-320 F
  • Use firm pressure for 12-15 seconds
  • Peel Hot 
  • Cover transfer again with parchment paper
  • Post-press for 2-4 seconds to seal edge of transfer

Heat Press Pressure Chart

Light pressure is usually between 25-30 psi if you’re using an automatic heat press. If you’re working with a manual heat press, light pressure means the upper platen will be easy to close with just one hand. 

Medium pressure is usually between 32-38 psi if you’re using an automatic heat press. If you’re working with a manual heat press, medium pressure means the upper platen takes some effort to close. Typically, you can close it with two hands and some effort. 

Firm pressure is usually 40 psi or higher if you’re using an automatic heat press. If you’re working with a manual heat press, firm pressure means the upper platen is difficult to close with two hands and a lot of muscle.