Follow these step-by-step instructions to apply Printomize America UV transfers for optimal results.

1. Prepare the Surface:
   • Clean the surface thoroughly with rubbing alcohol.
   • Ensure it is completely dry and free of dust, oil, or moisture.
2. Prep the Transfer Sheet:
   • Place the UV transfer on the carrier sheet.
   • Smooth it gently with a squeegee or flat tool, starting from the center outward to remove air bubbles.
3. Cut the Transfer:
   • Cut around the design, leaving a small margin to make peeling easier.
4. Expose the Adhesive:
   • Carefully peel back the protective film from the adhesive side.
   • Avoid touching the sticky surface to maintain adhesion.
5. Apply the Transfer:
   • Position the sticker onto the desired surface.
   • Press evenly with fingers, a squeegee, or a soft cloth to remove all air bubbles.
6. Remove the Front Cover:
   • Slowly peel off the front protective cover at a low angle.
   • Ensure the transfer adheres fully and smoothly to the surface.

Tip: For best results, handle transfers carefully and apply even pressure to avoid bubbles or peeling.