XP600 Headboard

XP600 Headboard

The headboard is the circuit board mounted on the moving carriage directly behind the printhead. It receives print data from the mainboard and converts it into the firing signals that drive each nozzle.

This is a replacement headboard for the Eyas 2 DTF printer. It also fits similar 30cm printers using Epson XP600 printheads.

Symptoms of a failing headboard

• Printhead stops firing entirely despite full ink and clean nozzles
• Whole colour channels missing from output
• Repeated nozzle deflection that cleaning cycles do not resolve
• Garbled or scrambled print data
• Printer reports a head communication or head board error
• Intermittent faults that worsen as the machine warms up

If a nozzle check shows the head dead but the ink system is working normally, the headboard is a more likely cause than the printhead — and considerably cheaper to replace.

Before you order

Confirm your printer uses an Epson XP600 printhead. Compare your existing board against the product photo before ordering, as revisions differ between production runs.

Installation

Once the board is installed it cannot be returned, refunded or exchanged. Please confirm compatibility before fitting.

Power down and unplug the printer completely. Handle only by the edges with an anti-static strap. Note the orientation of every ribbon cable before disconnecting and make sure each is fully seated and latched on reassembly — a partially seated ribbon is the most common cause of a replacement board appearing faulty. Run a nozzle check before production work.

Printer compatibility:

• Eyas 2 DTF Printer
• Similar 30cm printers using Epson XP600 printheads